Harmonic Vector Excitation Coding, abbreviated as HVXC is a speech coding algorithm specified in MPEG-4 Part 3 (MPEG-4 Audio) standard for very low bit rate speech coding. HVXC supports bit rates of 2 and 4 kbit/s in the fixed and variable bit rate mode and sampling frequency of 8 kHz. It also operates at lower bitrates, such as 1.2 - 1.7 kbit/s, using a variable bit rate technique.[1] The total algorithmic delay for the encoder and decoder is 36 ms.[2]

It was published as subpart 2 of ISO/IEC 14496-3:1999 (MPEG-4 Audio) in 1999.[3] An extended version of HVXC was published in MPEG-4 Audio Version 2 (ISO/IEC 14496-3:1999/Amd 1:2000).[4][5]

MPEG-4 Natural Speech Coding Tool Set uses two algorithms: HVXC and CELP (Code Excited Linear Prediction). HVXC is used at a low bit rate of 2 or 4 kbit/s. Higher bitrates than 4 kbit/s in addition to 3.85 kbit/s are covered by CELP.[6]

Technology

Linear Predictive Coding

HVXC uses Linear predictive coding (LPC) with block-wise adaptation every 20ms.[2] The LPC parameters are transformed into Line spectral pair (LSP) coefficients, which are jointly quantized.[2] The LPC residual signal is classified as either voiced or unvoiced. In the case of voiced speech, the residual is coded in a parametric representation (operating as a vocoder), while in the case of unvoiced speech, the residual waveform is quantized (thus operating as a hybrid speech codec).

Voiced (Harmonic) Residual Coding

In voiced segments, the residual signal is represented by two parameters: the pitch period and the spectral envelope.[2] The pitch period is estimated from the peak values of the autocorrelation of the residual signal.[2] In this process, the residual signal is compared against shifted copies of itself, and the shift which yields the greatest similarity by the measure of linear dependence is identified as the pitch period. The spectral envelope is represented by a set of amplitude values, one per harmonic.[2] To extract these values, the LPC residual signal is transformed into the DFT-domain.[2] The DFT-spectrum is segmented into bands, one band per harmonic. The frequency band for the m-th harmonic consists of the DFT-coefficients from (m-1/2)ω0 to (m+1/2)ω0, ω0 being the pitch frequency.[2] The amplitude value for the m-th harmonic is chosen to optimally represent these DFT-coefficients.[2] Phase information is discarded in this process. The spectral envelope is then coded using variable-dimension weighted vector quantization. This process is also referred to as Harmonic VQ.

To make a speech with a mixture of voiced and unvoiced excitation sound more natural and smooth, three different modes of voiced speech (Mixed Voiced-1, Mixed Voiced-2, Full Voiced) are differentiated.[2] The degree of voicing is determined by the value of the normalized autocorrelation function at a shift of one pitch period. Depending on the chosen mode, different amounts of band-pass Gaussian noise are added to the synthesized harmonic signal by the decoder.

Voiceless (VXC) Residual Coding

Unvoiced segments are encoded according to the CELP scheme, which is also referred to as vector excitation coding (VXC).[2] The CELP coding in HVXQ is performed using only a stochastic codebook. In other CELP codecs, a dynamic codebook is used additionally to perform long-term prediction of voiced segments. However, since HVXC does not use CELP for voiced segments, the dynamic codebook is omitted from the design.

See also

References

  1. ISO/IEC (2009-09-01), ISO/IEC 14496-3:2009 - Information technology -- Coding of audio-visual objects -- Part 3: Audio (PDF), IEC, retrieved 2009-10-07
  2. 1 2 3 4 5 6 7 8 9 10 11 Masayuki Nishiguchi (2006-04-17), Harmonic vector excitation coding of speech (PDF), Acoustical Science and Technology, retrieved 2009-10-09
  3. ISO (1999). "ISO/IEC 14496-3:1999 - Information technology -- Coding of audio-visual objects -- Part 3: Audio". ISO. Retrieved 2009-10-09.
  4. ISO (2000). "ISO/IEC 14496-3:1999/Amd 1:2000 - Audio extensions". ISO. Retrieved 2009-10-07.
  5. ISO/IEC JTC 1/SC 29/WG 11 (July 1999), ISO/IEC 14496-3:/Amd.1 - Final Committee Draft - MPEG-4 Audio Version 2 (PDF), archived from the original (PDF) on 2012-08-01, retrieved 2009-10-07{{citation}}: CS1 maint: numeric names: authors list (link)
  6. Karlheinz Brandenburg; Oliver Kunz; Akihiko Sugiyama. "MPEG-4 Natural Audio Coding - Natural Speech Coding Tools" (PDF). Retrieved 2013-03-25.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.